Hello:
I've just been using CS6 for a short while (recently upgraded from 3.0, which I've used quite extensively in the past). I was trying to figure out how to calibrate the vert scale to correspond to dB SPL. I set my USB mic preamp/mic combo using a calibrator so that 94 dBSPL = -20dBFS on the main meter and wave editor windows. When I try to set the 0 dB Reference in the Frequency Analysis window to -114 so that the scale will read the correct dB in SPL (-114+94=-20FS) it only shows the data below 50dB. I can't seem to get the vertical scale to show any values above 50dB.
Any body have any idea if there's another setting somewhere?? I can't think of any reason why it would be limited to 50, since it's just a label??
Thanks,